05
4. CAUTION!
● Do not leave the 3D Printer unattended.
● Do not make any modifications to the printer other than any approved SainSmart upgrades.
● When removing a model be careful not to use excessive force.
● The 3D printer must only be operated in a well ventilated area, noxious gasses can be released.
● Do not exceed the maximum print temperature of your printer or the filament you are using.
● When loading or unloading filament make sure the printer nozzle is well clear of the build plate (>50mm).
5. Filament and storage
● Follow any recommendations of your filament manufacturer.
● Do not use your printer to make anything that will come into contact with food unless specifically allowed by the filament manufacturer.
● Filament should be stored in clean and dry conditions. Filaments will absorb moisture and degrade over time if not kept dry.
● Do not open the filament from it’s sealed package until it is needed.
To Next Page
Loading...
