Product Manual – DOC. 8879C DM-NVX-36x(C) Encoders/Decoders • 13
Device Mode Locking
Device mode locking controls whether the SETUP button on a DM-NVX-36x and the
DMF-CI-8 front panel can be used to change the operating mode of the DM-NVX-36x
and DM-NVX-36xC devices, respectively. The operating mode determines when the
DM-NVX-36x(C) device functions as a receiver or transmitter.
NOTE: Device mode locking does not apply to the Mode setting in the Stream section
under the Settings tab.
To configure device mode locking:
1. Click the Settings tab and then click System Setup.
2. In the Device Mode Lock section, do either of the following:
• Allow the operating mode to be changed by setting the Control Lock toggle
switch in the Off (left) position (default setting).
• Prevent the operating mode from being changed by setting the Control Lock
toggle switch in the On (right) position.
Settings Tab – System Setup, Device Mode Lock Configuration
For additional information, refer to the online help of the web interface.
To Next Page
Loading...
Need help?
General
