4 • DM-NVX-36x(C) Encoders/Decoders Product Manual – DOC. 8879C
Rear Panel
The following illustration shows the rear panel of the DM-NVX-363 and DM-NVX-360.
DM-NVX-363 and DM-NVX-360 Rear Panel
PWR: Bicolor green/amber LED, indicates operating power is being supplied, lights
amber while booting and green when operating
SETUP: Recessed push button for on-screen IP address display and to change the
operating mode (transmitter or receiver). Red LED indicates that the
SETUP button
is pressed and times out automatically.
NOTES:
• When a DM-NVX-36x(C) decoder is connected to a DM-NVX-36x(C), DM-NVX-
35x(C), or DM-NVX-E30(C) encoder, pressing the
SETUP button on the decoder
for less than 10 seconds displays the encoder and decoder IP addresses on the
display connected to the HDMI output of the decoder.
• When a DM-NVX-36x(C) encoder is connected to a DM-NVX-36x(C), DM-NVX-
D30(C) or DM-NVX-D80-IOAV decoder, pressing the
SETUP button on the
encoder for less than 10 seconds displays the encoder IP address on the display
connected to the HDMI output of the encoder. In addition, the encoder and
decoder IP addresses are shown on the display connected to the HDMI output of
the decoder.
• When a DM-NVX-36x(C) encoder is connected to a DM-NVX-35x(C) decoder,
pressing the
SETUP button on the encoder for less than 10 seconds displays the
encoder IP address on the display connected to the HDMI output of the encoder.
In addition, the decoder IP address is shown on the display connected to the
HDMI output of the decoder.
• When the SETUP button is pressed for 10 seconds, a message appears on the
display stating that the button must be pressed again to change the operating
mode. Pressing the button a second time changes the operating mode from a
receiver (decoder) to a transmitter (encoder) or from a transmitter to a receiver
and reboots the device.
The
SETUP button can be used to change the operating mode only when Device
Mode Lock is disabled in the System Setup section under the Settings tab.
For additional information, refer to “Device Mode Locking” on page 13.
RESET: Recessed push button for hardware reset
INPUT SEL: Push button for manual input selection (HDMI or NV [network video])
To Next Page
Loading...
Need help?
General
