Product Manual – DOC. 8879C DM-NVX-36x(C) Encoders/Decoders • 47
Video Wall Processing
NOTE: Video wall processing applies to DM-NVX-36x(C) devices that function as
receivers.
Multiple DM-NVX-36x(C) receivers can be combined to configure a video wall composed
of up to 64 individual displays (up to eight columns of displays by eight rows of displays).
A separate DM-NVX-36x(C) device is required for each display.
To configure a video wall, use the web interface or SIMPL Windows as discussed in the
following sections.
Using the Web Interface
To configure video wall processing:
1. Click the Settings tab and then click Outputs.
2. In the Outputs table, click the Edit button.
3. In the Layout section:
a. In the Horizontal Bezel Compensation text box, enter a value ranging from 0
to
500 pixels.
b. In the Vertical Bezel Compensation text box, enter a value ranging from 0 to
500 pixels.
c. Select the Video Wall radio button.
d. In the Width combo box, select the desired number of rows of displays.
e. In the Height combo box, select the desired number of columns of displays.
f. Set the location of the display in the video wall by clicking the appropriate
box.
g. Click OK to save the changes.
4. Repeat steps 1-3 for each DM-NVX-36x(C) receiver that connects to a display for
inclusion in the video wall.
For additional information, refer to the online help of the web interface.
To Next Page
Loading...
