Crestron DM NVX Series User Manual

Product Manual – DOC. 8879C DM-NVX-36x(C) Encoders/Decoders • 37
Automatic Routing of Video Inputs
Automatic routing between video inputs can be enabled or disabled. When automatic
routing is enabled, the device automatically routes the last connected input.
To configure automatic routing, use the web interface or SIMPL Windows as discussed in
the following sections.
Using the Web Interface
To configure automatic routing of video inputs:
1. Click the Settings tab and then click Routing.
2. In the Input Routing section, enable automatic input routing by setting the
Automatic Input Routing toggle switch in the On (right) position (default
setting). To disable automatic input routing, set the switch in the Off (left)
position.
Settings Tab – Routing, Automatic Input Routing (DM-NVX-363[C] Screen Shown)
Using SIMPL Windows
Using the top-level programming slot for the DM NVX device, trigger the
<AutomaticRoutingEnabled> digital input join to enable automatic routing. To disable
automatic routing, trigger the
<AutomaticRoutingDisabled> digital input join.
For additional information, refer to the SIMPL Windows help file.

Crestron DM NVX Series Specifications

General

Latency	<1 Frame
Dimensions	Varies by model
Weight	Varies by model
Video Input	HDMI
Video Output	HDMI
Audio Formats	PCM, Dolby Digital, DTS
Audio Inputs	HDMI, Analog
Audio Outputs	HDMI, Analog
Control	Crestron Control System
HDCP	HDCP 2.2
Security	AES encryption