Supplemental Guide — Doc. 8327D TSS-7/TSS-10 • 21
Network
NOTE: The IP Address, Subnet Mask, and Default Gateway fields are required only if
DHCP is set to Disabled.
l Host Name: Enter the touch screen hostname.
l Domain Name: Enter the fully qualified domain name on the network.
l Primary Static DNS: Enter the primary DNS address.
l Secondary Static DNS: Enter the secondary DNS address.
l DHCP: Toggle the switch to enable or disable using DHCP.
NOTE: If DHCP is enabled, IP does not function until a reply has been received
from the server. The touch screen broadcasts requests for an IP address
periodically.
l IP Address: Enter the touch screen IP address on the network.
l Subnet Mask: Enter the touch screen subnet mask address on the network.
l Default Gateway: Enter the gateway router address on the network.
Device Display
l LCD
o
Auto Brightness: Toggle the switch to turn automatic brightness control for
the touch screen LCD display on or off.
o
ALS Threshold Value: If Auto Brightness is turned on, enter a value (1–100) for
the ALS (ambient light sensor) threshold, which is used for switching between
high and low auto-brightness presets.
o
Brightness: If Auto Brightness is turned off, enter a value (1‒100) for the LCD
display brightness.
o
Brightness High Preset: Enter a value (1‒100) for the LCD display high
brightness preset.
o
Brightness Medium Preset: Enter a value (1‒100) for the LCD display medium
brightness preset.
o
Brightness Low Preset: Enter a value (1‒100) for the LCD display low
brightness preset.
l Hard Key
o
Backlight: Toggle the switch to enable or disable the hard key backlight.
o
Backlight Brightness: If Backlight is enabled, enter a value (1‒100) for the key
backlight brightness.
o
Backlight Auto Brightness: If Backlight is enabled, toggle the switch to turn
automatic brightness control for the key backlight on or off.
To Next Page
Loading...
