5
Operating the LED Keypad
How to Arm the System before Exit (LED Keypad)
Preparing the System for Arming (LED Keypad)
Verify that all zone indicators are off, when all zones are closed (all doors, exits and windows are
closed and motion in the protected area is restricted or bypassed), the system is ready to be
armed. If one or more zone indicators are illuminated, it displays the open zones.
Close open zones, or bypass them. Bypass any zone you cannot close, <Bypass> indicator
flashes indicating bypassed zone(s). For details see page 9/10.
Note: Bypassed zones are not protected.
Arming the System (LED Keypad)
Before leaving premises you must arm the system.
Arming the alarm system turns on all detectors in the partition/s being armed.
1. Enter your code.
2. Press <ENTER>/
to arm the system.
There is an exit delay prior to the system being armed. During this delay time, a slow
beeping is heard to indicate that the system is not armed yet and reminds you to vacate
the protected area.
The A or B indicator lights up to indicate that the system is armed.
The indicators may go out few seconds after exit delay times out, depending on the installation
setting.
To disarm the system during the exit delay, press <ARM>/
Quick Arm (When enabled at installation - LED Keypad)
Press <ARM>/ to arm the system.
The A or B indicator is light, the system is armed.
During exit delay time, a slow beeping is heard reminding you to vacate the protected area.
Disarming the System
1. Enter your code.
2. Press <ENTER>/
.
The A or B indicator goes off, the system is now disarmed.
Stopping and Resetting Alarms
1. Enter your code.
2. Press <ENTER>/
.
This stops the alarm at any time, and also turns off any audible sirens
.
To Next Page
Loading...
