20
Arming the System While Staying Home
Arming the System in Stay Mode
This type of Arming is used when people are present within the protected area. At nighttime,
when the family is about to retire, perimeter zones are protected, but not the interior zones.
Consequently, interior movements are ignored by the system.
1. Press <STAY> /
.
2. Enter your PIN Code.
3. Press <ENTER> /
.
The LCD Screen Displays the ‘Stay’ mode Armed status of Area ‘A’ or ‘B’ (or Both) to
indicate that the system is now Armed in stay mode.
Quick Stay
This feature must be enabled at installation time.
Press <STAY> / . to arm the system.
During exit delay, you can leave the premises. If you wish to stay, or you don’t want
anybody to enter the protected premises, you can cancel the Entry/Exit delay by pressing
the <ENTER> /
key.
The slow beeping stops and the system is then Immediately Armed.
The LCD Screen Displays the ‘Stay’ mode Armed status of Area ‘A’ or ‘B’ (or Both) to indicate
that the system is now Armed in stay mode. The LCD Screen may turn off a few seconds after
exit delay expired (for Security and Power Saving Purposes), depending on the installer's setting.
Disarming the System
Enter your PIN Code and press <ENTER> / , or press <STAY> / , if enabled by
installer.
The LCD Screen Displays the ‘Disarmed’ status of Area ‘A’ or ‘B’ (or Both) to indicate that the
system is now Disarmed.
How to Arm Partitions (Areas) and how they work
The protected area can be grouped into 2 separate partitions (A & B) plus a Common Partition,
effectively allowing 3 separate groups of partitions that can be Armed & Disarmed. As the name
suggests, the Common partition Must be assigned correctly by the Installer so that it can be
Armed or Disarmed allowing the other 2 Separate partitions to function totally independently.
An example of this is, a building with 2 apartments with a common Entry or Foyer area. When
the owner of the first apartment comes home and Disarms Partition ‘A’, they will be Disarming
both their apartment as well as the Common Foyer Area. If the owner of the second apartment
comes home, they will Only Disarm their apartment (Partition ‘B’), etc.
To Arm Partition ‘A’, enter the User PIN Code for partition ‘A’.
To Arm Partition ‘B’, enter the User PIN Code for partition ‘B’.
Note: For Arming a Partition with a PIN Code, see page 19 “How to arm the system before exit”
During the Exit Delay, you can leave the premises. At the end of the Exit Delay, the LCD Screen
Displays Area ‘A’ or ‘B’ (or Both) to indicate that the system is Armed.
(The LCD Screen may turn off a few seconds after exit delay expired (for Security and Power
Saving Purposes), depending on the installer's setting.
To disarm partition, see "Disarming the System" on page 19.
To Next Page
Loading...
