28
15-second timer is active during the whole command control process so a period of 15 seconds
without a key press causes the panel to hang-up.
Using Local Command Control
If a command control code for outputs is programmed and the output/s are allowed to be locally
controlled from the keypad, then entering the 4 digit code at a keypad blanks the display and the
LCD Screen now indicate the output status. For example, if output 1 is on, the LCD Screen will
show the digit-1 to indicate that Output-1 is On. Pressing the “1” button at the panel keypad,
output 1 can be turned off provided it is allowed to be locally controlled. To leave local command
control mode simply press the <ENTER>/
button and the keypad returns to normal
operation. This feature works the same way that “Directly Controlling an Output” works only it
requires a code to access the function.
To Next Page
Loading...
