Crow Runner Series - How to Control Outputs and Devices

23
EVENT TYPE DEVICE EVENT TYPE DEVICE
ACTIVATION Zones 1-16 FIRE ALARM
(BUTTONS 4&6 ARE
PRESSED
TOGETHER)
Keypad Fire
BYPASS Zones 1-16 MEDICAL ALARM
(BUTTONS 7&9
PRESSED
TOGETHER)
Keypad Medical
DETECTOR TAMPER
(SHORT CIRCUIT)
Zones 1-8 ARMED A Area A is Armed
DETECTOR TAMPER
(OPEN CIRCUIT)
Zones 9-16 ARMED B Area B is Armed
WRONG CODE ALARM Code at Keypad # STAY MODE A Area A STAY Mode ON
CABINET TAMPER Cabinet or Siren STAY MODE B Area B STAY Mode ON
KEYPAD TAMPER
SWITCH
Tamper alarm at keypad DURESS ALARM Duress Alarm
At keypad #
LOW BATTERY Controller Battery SUPERVISED
RADIO ALARM
Supervised Radio
Passive Infra-Red
MAINS FAILURE Controller Mains Supply ZONE INACTIVITY
ALARM
Zones 1-16
FUSE FAILURE F1 or F2 Controller on-board
Fuses
TELEPHONE LINE
FAILURE
Phone Line Failure
RADIO ZONE LOW
BATTERY
Radio Zone 1-16 EXCESSIVE RE-
TRIES
Panel Dialer
PENDANT LOW BATTERY Radio Key User 1-20 FAILURE TO GET A
KISSOFF
Panel Dialer
PANIC BUTTON (or
BUTTONS 1&3 PRESSED
TOGETHER)
Keypad Panic
At keypad #
WALKTEST MODE Manual walk-test mode
How to Control Outputs and Devices
The keypad enables you to control external devices, such as an air-conditioner or heater. These
Devices Must First be Interfaced with the Runner System for them to be controlled using the
process explained below.
To activate or halt a device:
1. Press <CONTROL> /
.
The LCD Display Screen will change to the ‘Outputs Control Screen.
2. Press the (Output) number of the device (This is the Output Number where the Device is
Connected to inside the Runner Alarm Panel).
Up to eight different devices can be controlled via the keypad.
3. Press <ENTER> /
.
This activates or deactivates the selected device.
4. Press <CONTROL> /
.
The LED is light for each device ON.
5. Press <ENTER> /
to return to normal mode.