19
How to Arm the System before Exit
Preparing the System for Arming
Verify that there are No Zones indicated on the LCD Screen as open, when all zones are Sealed,
(i.e.: all doors & windows are closed and motion in the protected areas is restricted or Zones
bypassed), the system <Ready> /
light will come on and the system would be ready to be
Armed. If one or more zones become Un-Sealed (Open), the <Ready> /
light will go out and
the LCD Screen will indicate the Zone Number as being Open.
Close any open zones, or bypass them. Bypass any zone you cannot close, the LCD Screen
will indicate the number of the bypassed zone(s). For details see page-21.
Note: Bypassed zones are not protected (i.e.: they will Not activate the system if violated).
Arming the System
Before leaving the premises, you must Arm the system.
Arming the Alarm System Turns On All Detection Devices in the Partition(s) being Armed.
1. Enter your PIN Code.
2. Press <ENTER> /
to Arm the system.
There is an Exit Delay prior to the system being Armed. During this delay time, a slow
beeping is heard from the Keypad to indicate that the system is not Armed yet and reminds
you to vacate the protected area. The last 5 seconds of the Exit Delay produces quicker
beeps to alert you that the End of the Exit Delay is approaching and that you Must Vacate
Immediately, otherwise, on expiry of the Exit Delay, the System will be activated and Siren
will start to sound. If this happens, you will need to enter a Valid User’s PIN Number on the
Keypad to silence the siren and reset the Alarm.
However, When you Exit the premises before the Expiry of the Exit Delay, The Keypad’s LCD
Screen Displays Area ‘A’ or ‘B’ (or Both) to indicate that the system is Armed.
The indicators may go out few seconds after Exit Delay times out, depending on the
installation setting.
To Disarm the system during the Exit Delay, press the <ARM> / button.
Quick Arm (When enabled at installation)
Press <ARM> / to Arm the system.
The LCD Screen Displays Area ‘A’ or ‘B’ (or Both) to indicate that the system is Armed.
During exit delay time, a slow beeping is heard reminding you to vacate the protected area.
Disarming the System
1. Enter your PIN Code.
2. Press <ENTER> /
.
The LCD Screen Displays the ‘Disarmed’ status of Area ‘A’ or ‘B’ (or Both) to indicate that
the system is now Disarmed.
Stopping and Resetting Alarms
1. Enter your PIN Code.
2. Press <ENTER> /
.
This stops the alarm at any time, and also turns off any audible sirens
.
To Next Page
Loading...
