35
If you wished to return to the last saved version of the text simply press and hold the “A” button
for two seconds and the last saved text for zone one is displayed.
NOTE:
If the last saved version of text for Zone 1 was in fact the default setting, then pressing
“Control” then “1” or “A” causes the default text to return.
Resetting All Text to Default
While in “Local Edit Mode” it is possible to restore all of the customisable text fields to the factory
default settings.
When you enter in [PROG] /
-[801]-[ENTER] / display prompts you to press [801]-
[ENTER] /
again. Once you have pressed “801 enter”, all customisable text, for example,
zone names, user names, output names, are returned to the default text.
Copying Text to another LCD Keypad
If more than one LCD keypad is connected to the panel, it is possible to copy the edited Text
from one LCD keypad to all other LCD keypads connected to the same panel.
When you enter in [PROG] /
-[800]-[ENTER] / , all of the customisable text at the
keypad is transferred to all other LCD keypads connected to the control panel.
There is also an alternative method to transfer the text. Pressing the <CHIME>/
button
for two seconds while in “Local Edit Mode” performs the transfer. The text in your keypad is
transferred to all other LCD keypads connected to the panel.
Exiting Local Edit Program Mode
Press and hold the <PROGRAM>/ button for two seconds and the LCD keypad leaves Local
Edit Mode and return to Idle Mode or; Press the <PROGRAM>/
button repeatedly until the
display reads “Exit Programming”, then press the <ENTER>/
button to exit program mode.
To Next Page
Loading...
