24
Entering the User Program/Client Mode (Using LCD Keypad)
There are 2 levels of program modes, CLIENT mode and INSTALLER mode. Normally the
installer configures the system to give you access to the CLIENT mode so you can add, delete,
or change the user codes. To get into CLIENT mode (provided the system is NOT Armed) Press
<PROGRAM>/
enter Master code and <ENTER>/ . The LCD Display of the Keypad
will show ’Client:’ indicating that the system is in ‘User’ programming mode.
If you get a single long beep at this point and the LCD Display does Not say ‘Client’, this could
mean that either your code can Not access Program mode or that you pressed the Wrong
Buttons. It’s best to try again in case you had pressed the wrong button when entering your
Code into the keypad. Please make sure you are very careful when pressing the keypad buttons.
There is No reason to rush.
How to Exit Program Mode
To exit out of program mode press <PROGRAM>/ and <ENTER>/ . The LCD Screen
will exit the ‘Client’ Program Mode confirming that the system is No Longer in User programming
mode.
How to Change or Add Codes (Using LCD Keypad)
About Master Code and the User Code
The factory default master code (123) is intended as a preliminary control of the alarm system.
After the RUNNER is installed and put into service, the code can be changed to any code known
to the Master user (User-1). The Master user can Add up to 100 user codes and to limit access
rights to other users. The Master Code holder can ask the installer to define several User profiles.
Access rights are listed below:
User code has Area A and/or B permission
User code can Arm and/or Disarm an area
User code can Stay Arm and/or Stay Disarm an area
User code can change its code
User code can change user’s code
User code can Operate control Functions
User code can change dialer telephone numbers
User code can alter the real time clock
User can answer an incoming call and start up/down load
User can allow access to installer program mode from client mode.
Initiate Walk-test mode.
How to Change the Master Code (Using LCD Keypad)
NOTE: When changing the Master Code, please Ensure that you remember the new
Master Code that you enter. Otherwise, you will Not be able to use your system and
your systems installer will need to come back to reset the code. This may incur a
Service (Call Out) Fee.
While in CLIENT mode (see “Entering the user Program/Client Mode” above on page-23), Press
<PROGRAM>/
then 1 <ENTER>/ and 1 <ENTER>/ again. The current
Master Code digits will be displayed on the LCD Screen. To enter a new Master code, use the
numeric keypad buttons to enter your new Master code then press <ENTER>/
(At this
point, your Old Master Code will No Longer work. You MUST now start using your NEW Master
Code). The new Master Code will now be displayed followed either by three short beeps to
indicate correct entry or one long beep if not accepted. The Master Code can be any
combination of 1 to 6 digits. It is recommended to use at least a 4 digits code but a 6 digit code
will provide greater security.
To exit user Code Program mode, Press <PROG>/
and <ENTER>/ .
To Next Page
Loading...
