7
Enter the zone number (e.g. 01, 05, 12) one or more zones, the zone LED indicators lights up
to indicate that the zone is bypassed, following press <ENTER>/
, the Bypass LED flashes to
indicate zone(s) bypassed.
While in the Bypass mode it is possible to bypass more than one zone, press <BYPASS>/
,
the Bypass indicator lights to indicate that the system is in bypass mode.
Add the zone number (example, 03) one or more zones, the zone LED indicators lights to
indicate that the zone is bypassed, then press <ENTER>/
, the Bypass LED flashes to
indicate zone(s) bypassed.
To reset bypassed zones, press <BYPASS>/
, enter zone number (example, 07, 13), the
zone LED indicators go off to indicate that the zone is no longer bypassed. Press <ENTER>/
.
NOTE: Disarming automatically un-bypasses all zone.
Using Chime (If enabled at Installation)
A Chime (Day zone) is a detector that can be part armed while you are at home but working in
another part of the building. It can be programmed to operate a buzzer or light to let you know
you have a visitor.
To disable the Day (chime) zone, press <CONTROL>/
and <PROGRAM>/ , the Control
LED indicator lights up to indicate that Chime is disabled.
To enable Chime mode, you need to press two buttons together: Press <CONTROL>/
and
<PROGRAM>/
Together, the Control LED goes off to indicate that Chime is active.
Emergency Alerts
The special function of these three keys is best programmed by your installer to suit your
individual needs. Most commonly, these can be used to alert the Alarm Monitoring Company (the
system Must be monitored for this to occur. Please see your systems installer).
These Emergencies are “PANIC”, “FIRE”, and “MEDICAL” type alarms. When using the LED
keypad, the Panic alarm can be generated by either the single “Panic” button or by the
simultaneous operation of two buttons. Pressing two buttons simultaneously generates the Fire
and Medical alarms
How to initiate Panic
Press the <PANIC> / key.
OR
Press simultaneously keys <1>and <3> / <
>and < >.
How to initiate Medical Alarm
Press simultaneously keys <7> and <9> / < > and < >.
How to initiate Fire Alarm
Press simultaneously keys <4> and <6> / < > and < >.
Generate Threat or Duress
If you are compelled to disarm the system under threat, you must enter the duress digit before
the user’s code to activate the automatic dialer. The duress digit shifts up your usual code by
one digit. If your code is 345 and 8 is your duress digit, than entering 8345 modifies your code.
The modified duress code disarms the system in a normal way, but at the same time activates
the dialer silently to report a “duress event” without arousing suspicion. (For details ask the
installer).
To Next Page
Loading...
