Crow Runner Series - User Code Deletion and System Settings; How to Delete the User Code (Using LCD Keypad); How to set Time and Date

11
any combination of 1 to 6 digits. Entering the new code deletes the old code. Press
<ENTER>/
to save your new code, the new code is flashed back to you along with three
short beeps.
Repeat the procedure for all users.
Press <PROG>/
and <ENTER>/ to exit Local Program mode.
How to Delete the User Code (Using LED Keypad)
In client mode, press <PROGRAM>/ then 1 then <ENTER>/ and the User number (2
to 100) you intend to delete, press <ENTER>/
. The code is flashed back to you. Press
<BYPASS>/
to delete User code.
Press <ENTER>/
to save the change.
Press <PROG>/
and <ENTER>/ exit program mode.
Adding/Changing Telephone Numbers (Using LED Keypad)
Your panel accepts up to six phone numbers with a total of 16 digits. Your panel can be
programmed to dial all or any of these depending on the event which has occurred. (The six
phone numbers are at program address P181E 1-8E).
While in CLIENT mode, key in the following sequence <PROGRAM>/
<, P181E 1E >
<ENTER>/
(The address for telephone number 1), the existing number is flashed out at
the keypad then enter NEW TELEPHONE # then press <ENTER>/
The new numbers are
flashed back to confirm acceptance.
At any time you can enter in the address for the telephone number just to view the currently
programmed value then press the <PROGRAM>/
button to move on to the next address.
For example, P181E 1E= PH # 1, P181E 2E = PH# 2, P181E 6E = PH# 6.
NOTE: On the LED keypad, “0” is indicated by LED “Aux(0)”
How to set Time and Date
The alarm system has an internal clock that may be used to automatically Arm or Disarm the
alarm or turn Outputs On or off. It is also used to identify when events occurred in memory via
the LCD keypad. If you need to change the Time & Date it must be done from the CLIENT
mode. To change the Time & Date press
Press <PROGRAM/
<26> <ENTER>/ <2> <ENTER>/ <1-7> <ENTER>/
Where 1-7 = the current day (1=Sun, 2 = Mon to 7 = Sat)
Press <PROGRAM>/
<26> <ENTER>/ <1> <ENTER>/ <HHMM><ENTER>/
Where HH = Hour in 24 Hour Format and MM = Minutes
Press <PROGRAM>/
<26> <ENTER>/ <3> <ENTER>/ <DDMMYY>
<ENTER>/
.
Where DD =1-31 current date, MM= months 1-12, YY = year 00-99