Crow Runner Series - System Settings and Configuration; How to set Time and Date; How to Arm Partitions (Areas) and how they work; How to Bypass Zones

6
Arming the System While Staying Home (LED Keypad)
Arming the System in Stay Mode (LED Keypad)
This type of arming is used when people are present within the protected area. At nighttime,
when the family is about to retire, perimeter zones are protected, but not the interior zones.
Consequently, interior movements are ignored by the system.
1. Press <STAY>/
.
2. Enter your code.
3. Press <ENTER>/
.
The A or B indicator flashes indicating that the system is now armed in stay mode.
Quick Stay
This feature must be enabled at installation time.
 Press <STAY>/ to Stay Arm the system.
During exit delay you can leave the premises. If you wish to stay, or you don’t want anybody
to enter the protected premises, you can cancel the Entry/Exit delay by pressing the
<ENTER>/ key.
The slow beeping stops and the system will then immediately arm (cancelling the remaining
Exit period).
The A or B indicator flashes to indicate that the system is armed in stay mode. The indicators
may go out a few seconds after exit delay expired, depending on the installer's setting.
Disarming the System
Enter user’s code and press <ENTER>/ , or press <STAY>/ if enabled by installer.
The A or B indicator goes off to indicate that the system is disarmed.
How to Arm Partitions
The protected area can be grouped into 3 separate partitions (A or B). The system can be
grouped for User‘s convenience to separate, in a business environment, the offices from the
warehouse area, or in a private residence, the different rooms of the home, e.g., living room,
bedroom, etc.
To arm partition A enter user code for partition A
To arm partition B enter user code for partition B
Note: to arming partition with code see page 10 “How to arm the system before exit”
During exit delay you can leave premises. At the end of the procedure the A or B indicator lights
up to indicate that the partition A or/and B or C is armed.
(The indicators may go out after a few seconds, depending on the installer's setting).
To disarm partition, see "Disarming the System".
How to Bypass Zones
Bypass any zone that cannot be closed. You can bypass selected zones prior to arming. It is
also used to temporarily exclude a faulty zone from service, which requires repair.
To bypass a selected zone, press <BYPASS>/
, the Bypass indicator lights up to indicate that
the system is in bypass mode.