CSC TT250 - Page 56

TT250Owner’s andServiceManual
www.CSCMotorcycles.com
55

Ifyourassessmentindicatesthesteeringstembearings
requireadjustment,loosentheuppertripletreepinchbolts
ontheleftandtherightsideofthemotorcycle.Youdon’t
needtoremovethebolts;youonlyneedtoloosen
them.Theintentistoallowtheuppertripletreetomove

withrespecttotheforklegs.Theuppertripletreepinch
boltstakea10mmwrench.
Loosenboththeleftandrightpinchbolts.
Loosenthesteeringstembolt.Ittakesa22mmwrench.You
don’tneedtoremovethehandlebarstodothis,butitisa
tightfit
forthewrenchifyoudonot.Inthistutorial,wedid
notremovethehandlebars.
Useaspannertoeithertightenorloosenthesteeringstem
adjustornut.You’llwanttotightenitifthesteeringstem
bearingsaretooloose(asindicatedbyfreeplayorclicking
whenmoving
theforksbackandforth).
Iftheforkshavetoomuchresistancewhenturningthem
fromlefttoright(andviceversa),you’llwanttoloosenthe
steeringstemadjustornut.