CSC TT250 - Wheels and Tires

TT250Owner’s andServiceManual
www.CSCMotorcycles.com
61

Pushtherearwheelforwardandtakethechainofftherear
wheelsprocket.
Asyoupulltherearwheelawayfromthemotorcycle,
removethecalipermount.
Notethattherearwheelbushingontherightsideisintegral
tothecaliper.Therearenootherbushingsorwasherson

therightsideofthemotorcycle.
Theleftsideofthemotorcyclehasabushingthatfits
betweentherearwheelandtheswingarm.Itisorientation
insensitive(itcanbeinstalledeitherway).
Rearwheelinstallationisthereverseofremoval.Thecaliperboltsshouldbetorquedto22
ft‐lbs.The
rearaxlenutshouldbetorquedto35ft‐lbs.

Whentherearwheelisinstalled,thechainshouldbeadjustedandtherearwheelshouldbe
aligned.Thesemaintenanceactivitiesareaddressedinthechainadjustmentandwheelalignment
sectionofthismanual.
