CSC TT250 - Page 75

TT250Owner’s andServiceManual
www.CSCMotorcycles.com
74

Whenyouremovethefueltankfromthemotorcycle,two
hoseswillhangdown.Thelongeroneisthefueltank
overflowline.Itsimplyhangsdownfromthefueltank;the
otherendisnotattachedtoanything(itventsto
atmosphere).Theshorterhoseistheonethatattaches
to
thecarboncanister.You’llhavetoreinstalltheendofiton
thecarboncanisterbosswhenyoureinstallthefueltank
afteradjustingthevalves.
Atthispoint,wehavewhatwewant,andthat’saccesstothe
valvecover.
Thevalvecoverisattachedtothecylinder
headbythree
10mmbolts.Notethatthereisafourth10mmboltontopof
thevalvecover(it’stheoneinthephotobelowjustbeneath
andpartiallybehindthehose).Leavethatboltalone(do
notremoveitfromthevalvecover).
Doremovethethreeboltsthat
attachthevalvecovertothe
cylinderhead.
Detachthelargediameterhosefromtheexhaustgas
recirculationvalveshownbelow.