Curtis Instruments AC F4-A - Electrostatic Discharge (Esd) Immunity; Decommissioning and Recycling the Controller

APPENDIX B
Curtis AC F4-A Motor Controller – August 2020 Return to TOC
pg. 192
ELECTROSTATIC DISCHARGE (ESD) IMMUNITY
Curtis motor controllers contain ESD-sensitive components. It is therefore necessary to protect them
from ESD damage. See Table 4 for the controller ESD ratings.
ESD immunity is improved by either providing sucient distance or isolation between conductors
and the ESD source so that a discharge will not occur.
DECOMMISSIONING AND RECYCLING THE CONTROLLER
e controller is for installation into an Original Equipment Manufacturer (OEM) vehicle. As a
component, it has no function unless installed as part of a vehicle’s electrical or electro-hydraulic
control system.
For controller decommissioning and recycling:
1. Follow the OEM’s vehicle decommissioning instructions.
2. Follow all applicable landll directives or regulations for Electrical and Electronic Equipment
(EEE) waste.
Quick Link:
Table 4 p.9