Curtis Instruments AC F4-A User Manual

APPENDIX D
Curtis AC F4-A Motor Controller – August 2020 Return to TOC
pg. 198
not select those either. Rather, use any of the four methods shown below to open the Project Explorer
dialog box. New projects will be created (set up) using this Project Explorer window. e rst step in
creating a new project is to create the project itself. Devices are then added to the project (see Step
2c). Devices added to a project (i.e., within a saved project) can always be edited or deleted from the
project. e steps to create a project with an F-series controller are as follows:
Step 1: Open the Project Explorer dialog box (window) by using one of these New Project methods.
Step 2 – 3: Within Project Explorer, work from the top-down completing each entry. If an entry’s
value is unknown, use the default. Entries are always editable by re-opening the saved
project’s Project Explorer window and following these same steps.
Ctrl + N
1
2

Curtis Instruments AC F4-A Specifications

General

Brand	Curtis Instruments
Model	AC F4-A
Category	Controller
Language	English