Curtis 1222 - Page 39

Curtis 1222 Manual, os 15
35
2 9 J A N U A R Y 2 0 1 3 D R A F T
2 = Sin/Cos Sensor feedback, where Analog 5 and Analog 6 inputs
are connected to a sine-cosine transducer. This transducer is
mounted in a location where it can sense the actual wheel
position.
When this position feedback is used, sine and cosine
channels are both required (and together serve as the primary
and supervisory feedback devices).
NAME PIN FUNCTION
Analog 5 6 Sine input (Feedback Analog 5)
Analog 6 17 Cosine input (Feedback Analog 6)
FEEDBACK DEVICE PARAMETER, cont’d
3 — PROGRAMMABLE PARAMETERS: Position Feedback Parameters
3 = Sawtooth Sensor feedback, where Analog 5 and Analog 6 inputs
are connected to a sawtooth transducer. This transducer is
mounted in a location where it can sense the actual wheel
position.
When this position feedback is used, primary sawtooth and
offset sawtooth channels are both required (and together serve
as the primary and supervisory feedback devices).
NAME PIN FUNCTION
Analog 5 6 Primary Sawtooth input (Position Analog 5)
Analog 6 17 Offset Sawtooth input (Position Analog 6)