62
Curtis 1222 Manual, os 15
2 9 J A N U A R Y 2 0 1 3 D R A F T
4a — MONITOR MENU: Position Feedback
Monitor Menu: POSITION FEEDBACK
DISPLAY
VARIABLE RANGE DESCRIPTION
Wheel Position (deg) -180.0° – 180.0° The final wheel position.
0x2000 0x00 -32768 – 32767
Wheel Position 2 (deg)
-180.0° – 180.0° The operator’s redundant final wheel
0x4458 0x00 -32768 – 32767 position.
Wheel Position 2 is compared to Wheel
Position, and if the difference exceeds the
programmed Wheel Position Tolerance, a
fault is issued (code 56: Wheel Position
Supervision).
Left Stop Reached On / Off Flag indicating the left stop has been
0x4421 0x00 On / Off reached.
Right Stop Reached On / Off Flag indicating the right stop has been
0x4422 0x00 On / Off
reached.
Monitor Menu: POSITION FEEDBACK → Analog Input
DISPLAY
VARIABLE RANGE DESCRIPTION
Analog 5 0 – 10.00 V The voltage measured at the Position
0x4411 0x00 0 – 1023 Analog 5 input (pin 16).
Analog 6 0 – 10.00 V The voltage measured at the Position
0x4480 0x00 0 – 1023 Analog 6 input (pin 17).
Position Raw (deg)
-180.0° – 180.0° The angle calculated by the primary
0x44C0 0x00 -32768 – 32767 microprocessor from the input voltages
(pins 16 and 17) for the Sin/Cos or
Sawtooth sensors.
Position 2 Raw (deg)
-180.0° – 180.0° The angle calculated by the supervisory
0x44C1 0x00 -32768 – 32767 microprocessor from the input voltages
(pins 16 and 17) for the Sin/Cos or
Sawtooth sensors.
To Next Page
Loading...
