Curtis 1297 - Page 117

Curtis PMC 1297 Manual
A-20
APPENDIX A: GLOSSARY
Hourmeter
ADJ HRS HIGH OEM 0 151 0 — page 59
ADJ HRS MID OEM 0 255 0 — page 59
ADJ HRS LOW OEM 0 255 0 — page 59
SET TOTL HRS OEM OFF — page 60
SET TRAC HRS OEM OFF — page 60
SET PUMP HRS OEM OFF — page 60
SRVC TOTL HRS OEM 0.0 50.0 0.0 100 hours page 60
SRVC TRAC HRS OEM 0.0 50.0 0.0 100 hours page 60
SRVC PUMP HRS OEM 0.0 50.0 0.0 100 hours page 60
DIS TOTL HRS OEM 0 250 10 hours page 61
DIS TRAC HRS OEM 0 250 10 hours page 61
DIS PUMP HRS OEM 0 250 10 hours page 61
TRAC FAULT SPD OEM 0 100 100 percent page 61
PUMP FAULT SPD OEM 0 100 100 percent page 61
SERVICE TOTL OEM OFF — page 62
SERVICE TRAC OEM OFF — page 62
SERVICE PUMP OEM OFF — page 62
Battery Discharge Indicator (BDI)
FULL VOLTS OEM EMPTY VOLTS RESET VOLTS 204 0.01 VPC page 63
EMPTY VOLTS OEM 90 FULL VOLTS 173 0.01 VPC page 63
RESET VOLTS OEM FULL VOLTS 300 209 0.01 VPC page 63
1297 DEFAULT MIN MAX DEFAULT DESCRIPTION
PARAMETER ACCESS VALUE VALUE SETTING UNITS IN
MANUAL
Table D-1, continued
The 1297’s remaining parameters are listed below. For these lists, Program Menu order is used rather than
alphabetical order.
APPENDIX D: PROGRAMMABLE PARAMETERS
D-3