ANNEX G: SUNDRIES PAGE 75
the input encoder signals (can be provoked by a parasite, a
fault in the encoder or a short-circuit on the encoder
phases).
LAST
Displayed in
mode when the sequence shown is the
last of the product.
NEXT
Is displayed during successive display (
key) of the
sequences which exist in the buffer (except for the last
sequence which indicates END).
NO ACTIVE
Indicates an attempt to change to
or mode on
a sequence where the CY is programmed at 0.
NO PLACE
Indicates that the product list memory has no more space
available.
PAUSE
Axis pause.
PREVIOUS
Same as NEXT but with the
key.
RUN
Indicates that the transmission is being made correctly.
This message flashes slowly for the duration of the trans-
mission.
STOP
Indicates that the transmission has been interrupted by
means of the DNC STOP key.
STORED
Indicates that the storage operation has been made cor-
rectly.
synchro
The maximum authorized separation (X1<->X2) has been
exceeded.
TEACH OK
The TEACH operation has been made correctly.
TIME OUT
Indicates that the DNC has not received any valid informa-
tion since the beginning of the transmission, and thus
returns the command to the operator. This message ap-
pears after about 30 seconds.
TOL ZONE
Displayed in
or mode when the axes are
positioned outside of their tolerances. Generally, just press
the start of the front panel to position the axes will do.
UNDEFINED
Refusal to change to
or , if the parameters
vital to execution are not or only partially programmed
and thus prevent the verification calculations.
Var KO
One of the DNC inputs "SERVO DRIVER OK" is not (no
longer) active (+24 VDC).
To Next Page
Loading...
Need help?
General
