ANNEX G: SUNDRIES PAGE 55
IN CASE OF FAILURE
INITIAL CHECKS TO BE CARRIED OUT
Switch the machine off then on again.
Check the program (safety factors).
Check that the axes can be moved in manual mode.
Compare the machine parameters to those on the written list made
during the installation.
Check the power supply voltages (to do this please refer to the tech-
nical manual).
Check that the keyboard responds.
Check that the front panel lamps light up.
POSSIBLE MEMORY POLLUTION
After performing the initial checks above, it is then likely that you have a
memory pollution problem. To locate the fault, proceed as follows:
Switch off the DNC.
Switch on the DNC.
Follow the instructions in the next chapter The Initialization page.
To Next Page
Loading...
Need help?
General
