SAFETY AND MAINTENANCE INSTRUCTIONS PAGE I
SAFETY AND MAINTENANCE INSTRUCTIONS
The operator must be trained for working with the
machine on which the numerical control is installed.
Improper use of the numerical control can cause
heavy damage on equipment and/or injuries to peo-
ple.
Modification of machine parameters can cause im-
portant material damage or lead to irregular product
quality.
The rear panel may only be removed by a qualified
technician (danger of electrocution).
Do not expose the numerical control to excessive
humidity so as to avoid any risk of electrocution and
any deterioration of the equipment.
Make sure the numerical control is disconnected
from the mains power before carrying out any clean-
ing. Do not use liquids based on alcohol or ammo-
niac.
In case of malfunction of the numerical control, call a
technician.
Do not expose the numerical control to direct sun
rays or any other heat source.
Do not place the numerical control in the neighbour-
hood of magnetic equipment such as transformers,
motors or devices which generate interference (weld-
ing machines, etc.)
Replace fan filters at regular intervals so as to avoid
overheating.
To Next Page
Loading...
Need help?
General
