40/40
ModEva Pac User Manual
April
2016
V2.3
The process to restore a backup of the system is very similar to creating the backup itself.
Proceed as follows:
reSTorinG a backup of The SySTeM
Setting inStructionS:
1. Turn the NC off.
2. Plug the backup USB key in the NC, turn it back on, and execute points 6 and 7 of
the previous procedure.
3. Once in the following menu, select option 3. RESTORE SYSTEM DISK.
* ..... *
* *
***************************************************
****************************************************
* *
* 1. LIST ARCHIVE FILE(S) *
* 2. BACKUP SYSTEM DISK *
* 3. RESTORE SYSTEM DISK *
* 0.[X] EXIT - REBOOT PC *
* *
****************************************************
PICK A KEY (1,2,3,0 or X)
4. Enter the name of the backup you want to restore.
***************************************************
* *
* ENTER THE NAME OF THE ARCHIVE FILE WITHOUT *
* THE SUFFIX BK AND EXTENSION (.TBI), THEN *
* PRESS ENTER OR JUST PRESS ENTER TO ABORT. *
* *
* NOTE: THE PC WILL AUTOMATICALLY REBOOT *
* AT COMPLETION OF THE RESTORE *
* *
***************************************************
AVAILABLE FILE(S) :
BK160425
ENTER A FILENAME (numbers only): BK_
The backup file are automatically named BK followed by the date they were
created in the YYMMDD format.
5. The restore operation starts.
***************************************************
* *
* DO NOT TURN OFF THE PC !!! *
* RESTORE IS RUNNING ... *
* *
***************************************************
6. The NC automatically reboots at the end of the process.
If the storage media (CF card) has to be replaced, make sure it is with the same
model of the same manufacturer. If not possible, contact Cybelec to get an
approved replacement.
To Previous Page
Loading...