27/40
ModEva Pac User Manual
April
2016
V2.3
bendinG, TeSTS and correcTionS
This chapter explains how to proceed in order to execute a product. This way of doing is
destined only to demonstrate how to use the numerical control.
The testing and adjusting operations can be carried out in the order decided by the
operator.
•
Bending SPeed, defines the downward bending speed and the upward moving speed
from BDC to Pinch Point point.
•
LoW SPeed diStance, defines the portion (expressed in %) of the upward movement
between the TDC and the Pinch Point which will be carried out at low speed; the
continuation of the upward movement is made at high speed.
Complementary explications are found in the 2D Reference Manual.
Setting inStructionS:
1. Go into semi-automatic mode .
2. If necessary, move to the first sequence by means of the
and keys.
3. Press the start key
in order to position the axes on the first sequence.
4. Carry out the bend with a trial product.
5. Measure the flap and the obtained angle.
6. Touch the
button and select correctionS in the list.
In the screen above, the correction of -2.00 MM corresponds to the material
thickness when programming section 2 in Bend Numerical Page (Direct
Programming), page 25.
7. If necessary, correct the flap (in this example, a correction of X = - 0.10 is assumed)
for the current bend.
To Next Page
Loading...