9 Messages/Glossary
If your MR400 produces a message or abbreviation that you do not understand,
use this table for help.
Text Notes Section(s)
12HR 12 hour clock format. 0
24HR 24 hour clock format. 0
A1 Speed alarm 1. 5.7.4
A2 Speed alarm 2. 5.7.4
ALRM Alarm clock setting/Speed alarm setting 5.7.4
APR April
AUG August
AUTOMATIC TURN
OFF AFTER 2
HOURS IN FOR
HIRE
Prompt in INFO Menu for setting of Auto Turnoff
feature.
5.5.3
AVE Average (Speed), Totals
BASIC Basic totals system setting. 7.1,6.3
BRIGHT Display brightness setting. 5.5.1
CAL Calibration 5.7.1
CHNG Change. (Rate changes), Totals. 6.4
CODE. Code. (Tariff Code) 5.6.2
CONT-ACT Part of 2-part “CONTACT” message flashing in
extras window.
5.6.4
DATE “Date” from “End Date”. Indicates expiry date of
tariff.
5.6.2
DEC December
DISABLE FEATURE
– THE CLOCK IS
NOT SET SO THE
METER IS
DISABLED
Message in the Disable Feature menu entry when
the clock is not set.
5.4.3
DIST Distance. (Totals) 6.4
DONE Displayed during software programming. Indicates
that an operation is complete.
DOOR HANDLE
LAMPS
Prompt for user to set the Door Handle Illumination
option.
5.7.7
DSAB “Disable”. Part of the Disable Feature Info menu
entry.
5.4.3
END Tariff End Date. 5.6.2
ENTER PIN Prompt to enter a Pin Number.
ERROR Indicates an error condition.
ERR 0 On power up, the MR400 cannot recognise its
internal memory. Try re-applying the power.
ERR 1 Error during software upgrading. (Write failure)
To Next Page
Loading...
Need help?
General
