D-Link DCS-5220

65D-Link DCS-5220 User Manual
Section 3 - Configuration
Turn off the
LED indicator:
Restore:
Save
conguration:
Restore
conguration:
Reboot:
Select this option to turn off the LED next to the
lens. This will prevent anyone from observing the
operation of the network camera.
Click the Restore button to reset the camera back
to its factory default settings. This will remove all the
conguration settings that were previously made.
Click to save the camera’s conguration le to your
computer for restoration purpose.
You may browse and load the conguration le,
then click Load Conguration to restore the pre-
congurated or saved settings.
Click the Reboot button to restart the camera.
SYSTEM
The Backup and Restore page will allow you to turn the front panel LED off, restore factory default settings, and reboot
the camera.