DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
The following window is the CPU Interface Filtering Rule Table for Packet Content.
Figure 9- 13. CPU Interface Filtering Rule Table – Packet Content
To remove a previously created rule, select it and click the
button. To add a new Access Rule, click the Add button:
Figure 9- 14. CPU Interface Filtering Rule Configuration - Packet Content
To set the Access Rule for Packet Content, adjust the following parameters and click Apply.
Parameters Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be set from 1 - 5.
Type
Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
•
•
•
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask instructs the Switch to examine the packet header.
111
To Next Page
Loading...
