D-Link DSL-245GE - Ipsec

42D-Link DSL-245GE User Manual
Section 4 - Conguration
IPSec
IPSec facilitates VPN communications with security capabilities. This page
allows you to create an IPSec tunnel between two sites and set parameters for
authentication method and encryption algorithm.
Click Add Rule and congure the following to set up an IPSec prole for VPN
connections:
IPSec Settings
Connection Name: Name this IPSec connection.
Local Gateway IP: Enter the IP address of the local gateway for this tunnel.
Remote Gateway
IP:
Enter the IP address of the remote gateway for this tunnel.
Local Access
Range:
Select either Single IP or Subnet. Note that the local and remote
access range should use dierent subnetworks.
Local IP Address: Enter the IP address of the local device that can use this tunnel.
IP Subnet Mask: Enter the subnet mask if you choose Subnet for Local Access Range.
Remote Access
Range:
Select either Single IP or Subnet. Note that the local and remote
access range should use dierent subnetworks.
Remote IP
Address:
Enter the IP address of the remote device that can use this tunnel.