D-Link DSL-245GE - Connection Type: Pppoe

38D-Link DSL-245GE User Manual
Section 4 - Conguration
Connection Type: PPPoE
Select PPPoE if your ISP provides and requires you to enter a PPPoE username
and password in order to connect to the Internet.
WAN Settings
Connection: Select PPPoE.
Service List: Select a service type from the list. Choose from INTERNET, TR069,
TR069_INTERNET, or OTHER. This information should be provided
by your ISP. If you are conguring your connection manually and
your ISP has not specied this setting, INTERNET is recommended.
Protocol Select IPv4, IPv6 or IPv4/IPv6 for both IPv4 and IPv6 addressing
mechanism. If you choose IPv6, refer to the below IPv6 Settings.
Username: Enter the username provided by your ISP.
Password/Conrm
Password:
Enter the password provided by your ISP. Then enter it again to conrm
your entry.
Advanced Settings
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP. The default is 1492.
NAT Enable: Network address translation (NAT) translates private IP addresses to
public IP addresses before allowing private IP networks to connect
to the public network.