D-Link DSL-245GE - Static Route

73D-Link DSL-245GE User Manual
Section 4 - Conguration
Static Route
The Static Routes page allows you to dene custom routes to control how data
trac is moved around your network. To access this page, go to Features >
Static Route. Select IPv4 Static Routes or IPv6 Static Routes.
If you wish to remove a rule, click
in the Delete column. If you wish to edit a
rule, click
in the Edit column. If you wish to create a new rule, click the Add
Rule button. Click Save when you are done.
Complete the following to create or edit a rule:
Create New Rule
Destination
Address:
Enter the destination subnetwork IP address.
Destination
Subnet Mask
(IPv4):
Enter the subnet mask of the destination address. The subnet mask
determines an IPv4 subnetwork.
Prex Length
(IPv6):
Enter the IPv6 prex length (0~128), which is the number of prex
bits of an IPv6 address. The prex determines an IPv6 subnetwork.
Gateway IP
Address:
Enter your next hop gateway to be taken if this route is used.
Service Number: Specify the interface to transit the packets of this static route.
Metric: The route metric is a value from 0 to 15 that indicates the cost of
using this route.
Click Apply when you are done. A maximum of 16 rules can be dened.