D-Link DSL-245GE - Page 69

65D-Link DSL-245GE User Manual
Section 4 - Conguration
Destination IP
Address/Port:
Enter the starting destination IP address (e.g. 1.1.1.1 for IPv4 or 2001::1
for IPv6) and starting port that the rule will apply to. Depending on
whether it is a upstream or downstream trac, this can be either a
WAN or LAN IP address. Both a single IP address and a range of IP
addresses can be used.
End Destination
IP Address/Port:
Enter the ending destination IP address (e.g. 1.1.1.5 for IPv4 or
2001::5 for IPv6) and ending port that the rule will apply to. For a
single IP address assignment, enter the same address as the starting
IP address. Depending on whether it is a upstream or downstream
trac, this can be either a WAN or LAN IP address.
Destination
Subnet Mask/
Prex Length:
Enter the subnet mask of the destination IP address (four 8-bit octets).
Or enter the prex length for IPv6 addressing scheme (1-128).
Interface: Select a Service Number of the WAN Interface to which the rule
should apply.
Click
Apply to save your settings. A maximum of 20 rules can be dened.