DWR-921 4G LTE Router
User Manual
Configuring via Web-based Interface
Creating 6in4 WAN Connection
!
Before configuring the connection, please first register on a tunnel broker’s web site.
On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 93. The page for creating a new 6in4 connection.
Parameter Description
General Settings
Connection name
A name for the connection for easier identification.
Enable connection
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
Ping
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
RIPng
Move the switch to the right to allow using RIPng for this
connection.
Remote host Enter the IPv4 address of the server provided by the tunnel broker.
Client IPv6 address
Enter the IPv6 address of the router provided by the tunnel broker
(without specifying the prefix length).
Server IPv6 address
Enter the IPv6 address of the server provided by the tunnel broker
(without specifying the prefix length).
Page 108 of 255