D-Link dxs-3350sr - Page 142

DXS-3350SR Gigabit Layer 3 Switch
The following parameters may be set or viewed:
Parameter Description
Dest Protocol
Allows for the selection of the protocol for the destination device. Choose between
RIP and OSPF.
Src Protocol
Allows for the selection of the protocol for the source device. Choose between RIP,
OSPF, Static and Local.
Type
Allows for the selection of one of six methods of calculating the metric value.
The user may choose between All, Internal, External, ExtType1, ExtType2, Inter-
E1, Inter-E2. See the table above for available metric value types for each source
protocol.
Metric
Allows the entry of an OSPF interface cost. This is analogous to a Hop Count in
the RIP routing protocol.
Click Apply to enter the new settings. To delete an entry, click the corresponding
under the Delete heading.
NOTE: The source protocol (Src Protocol) entry and the destination
protocol (Dest Protocol) entry cannot be the same.
133