DXS-3350SR Gigabit Layer 3 Switch
The following RIP settings can be applied to each IP interface:
Parameter Description
Interface Name
The name of the IP interface on which RIP is to be setup. This interface must be
previously configured on the Switch.
IP Address
The IP address corresponding to the Interface Name showing in the field above.
TX Mode <Disabled>
Toggle among Disabled, v1 Only, v1 Compatible, and v2 Only. This entry specifies
which version of the RIP protocol will be used to transmit RIP packets. Disabled
prevents the transmission of RIP packets.
RX Mode <Disabled>
Toggle among Disabled, v1 Only, v2 Only, and v1 or v2. This entry specifies which
version of the RIP protocol will be used to interpret received RIP packets. Disabled
prevents the reception of RIP packets.
Authentication
Toggle between Disabled and Enabled to specify that routers on the network should
us the Password above to authenticate router table exchanges.
Password
A password to be used to authenticate communication between routers on the
network.
State
Toggle between Disabled and Enabled to disable or enable this RIP interface on the
Switch.
Interface Metric
A read only field that denotes the Metric value of the current IP Interface setting.
Click Apply to implement changes made.
141
To Next Page
Loading...
