D-Link NetDefend DFL-210

Log Message
Temperature monitor <index> (<name>) is outside the specified limit.
Current value is <current_gpio> <unit>, lower limit is <min_limit>,
upper limit is <max_limit>
Explanation
The sensor reports that the GPIO value is back inte the normal range.
Gateway Action
None
Recommended Action
None.
Revision
1
Parameters
index
name
unit
current_gpio
min_limit
max_limit
2.16.9. free_memory_warning_level (ID: 04000101)
Default Severity
WARNING
Log Message
Free memory has fallen below the specified limit of
<limit_percentage> percent, limit classified is <severity>, free
<free_mem> MB of total <total_mem> MB, percentage free
<free_percentage>
Explanation
The amount of free memory is getting low.
Gateway Action
None
Recommended Action
Review the configuration and disable or lower settings to reduce
memory consumption.
Revision
1
Parameters
limit_percentage
total_mem
free_mem
free_percentage
severity
2.16.10. free_memory_warning_level (ID: 04000102)
Default Severity
WARNING
Log Message
Free memory has fallen below the specified limit of <limit_megabyte>
megabyte, limit classified is <severity>, free <free_mem> MB of total
<total_mem> MB, percentage free <free_percentage>
Explanation
The amount of free memory is getting low.
Gateway Action
None
Recommended Action
Review the configuration and disable or lower settings to reduce
memory consumption.
Revision
1
2.16.9. free_memory_warning_level
(ID: 04000101)
Chapter 2. Log Message Reference
223