D-Link NetDefend DFL-210

rule protocol
Explanation
Failed to insert rule since forced NAT protocol do not match rule
protocol.
Gateway Action
VPN_tunnel_disabled
Recommended Action
Reconfigure_IPsec.
Revision
1
2.22.92. no_authentication_method_specified (ID:
01802100)
Default Severity
ERROR
Log Message
Neither pre-shared keys nor CA certificates nor EAP are specified for
a tunnel
Explanation
No authentication method is specified for the tunnel.
Gateway Action
VPN_tunnel_disabled
Recommended Action
Reconfigure_IPsec.
Revision
1
2.22.93. no_key_method_configured_for tunnel (ID:
01802102)
Default Severity
ERROR
Log Message
Tunnel does not specify any keying method (IKE or manual)
Explanation
No keying method (IKE/manual) is configured for tunnel.
Gateway Action
VPN_tunnel_disabled
Recommended Action
Reconfigure_IPsec.
Revision
1
2.22.94. invalid_configuration_of_force_open (ID:
01802104)
Default Severity
ERROR
Log Message
Auto-start rule does not specify single IP address or domain name for
its remote peer
Explanation
Can not use Auto-start rule (force open) for roaming tunnels.
Gateway Action
VPN_tunnel_disabled
Recommended Action
Reconfigure_IPsec.
2.22.92. no_authentication_method_specified
(ID: 01802100)
Chapter 2. Log Message Reference
275