D-Link NetDefend DFL-210

Log Message
AH configured but not supported
Explanation
Tunnel [tunnel] configured for AH, but AH is not supported.
Gateway Action
VPN_tunnel_disabled
Recommended Action
Reconfigure_tunnel.
Revision
1
Parameters
tunnel
2.22.106. invalid_tunnel_configuration (ID: 01802208)
Default Severity
ERROR
Log Message
No IPsec transform (AH or ESP) specified for tunnel <tunnel>
Explanation
IPsec transform type must be specified for tunnel.
Gateway Action
VPN_tunnel_disabled
Recommended Action
Reconfigure_tunnel.
Revision
2
Parameters
tunnel
2.22.107. invalid_tunnel_configuration (ID: 01802209)
Default Severity
ERROR
Log Message
Auto-start tunnel <tunnel> configured for `per-port' or `per-host' SA.
Explanation
`per-port' or `per-host' SA can not be specified for auto-start tunnels
[tunnel].
Gateway Action
VPN_tunnel_disabled
Recommended Action
Reconfigure_tunnel.
Revision
1
Parameters
tunnel
2.22.108. invalid_tunnel_configuration (ID: 01802210)
Default Severity
ERROR
Log Message
Both `auto-start' and `dont-initiate' specified for tunnel <tunnel>
Explanation
Both `auto-start' and `dont-initiate' can not be specified for a tunnel.
Gateway Action
VPN_tunnel_disabled
Recommended Action
Reconfigure_tunnel.
2.22.106. invalid_tunnel_configuration
(ID: 01802208)
Chapter 2. Log Message Reference
279