EasyManua.ls Logo

D-Link NetDefend DFL-210

D-Link NetDefend DFL-210
476 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Revision
1
Context Parameters
Rule Name
Packet Buffer
2.46.7. enet_hw_sender_multicast (ID: 04400416)
Default Severity
WARNING
Log Message
Ethernet hardware sender is a multicast address. Dropping.
Explanation
The Ethernet hardware sender address is a multicast address. The
packet will be dropped.
Gateway Action
drop
Recommended Action
Investigate if there are equipment sending packets using a multicast
address as sender MAC address. If there are, try to change the
behaviour of that equipment.
Revision
1
Context Parameters
Rule Name
Packet Buffer
2.46.8. relay_stp_frame (ID: 04400417)
Default Severity
INFORMATIONAL
Log Message
Relaying STP frame from <recvif> to switched interfaces
Explanation
An incomming STP frame has been relayed to all switched interfaces
in the same switch route as [recif].
Gateway Action
allow
Recommended Action
None.
Revision
1
Parameters
recvif
2.46.9. dropped_stp_frame (ID: 04400418)
Default Severity
INFORMATIONAL
Log Message
Dropping STP frame from <recvif>
Explanation
An incomming STP frame has been dropped.
Gateway Action
drop
Recommended Action
None.
Revision
1
Parameters
recvif
2.46.7. enet_hw_sender_multicast (ID:
04400416)
Chapter 2. Log Message Reference
447

Table of Contents

Other manuals for D-Link NetDefend DFL-210

Related product manuals