D-Link NetDefend DFL-210

2.28. NATPOOL
These log messages refer to the NATPOOL (Events related to NAT Pools) category.
2.28.1. uninitialized_ippool (ID: 05600001)
Default Severity
ERROR
Log Message
NATPool <poolname> has not been initialized
Explanation
The NATPool is not initialized. This can happen if the NATPool
contains no valid IP addresses. If the NATPool is configured to use an
IPPool, no IP addresses have been received form the IPPool.
Gateway Action
drop
Recommended Action
If the NATPool is configured to use an IPPool, verify that addresses
have been loaded from IPPool.
Revision
1
Parameters
poolname
2.28.2. removed_translation_address (ID: 05600002)
Default Severity
WARNING
Log Message
Translation IP address <address> does no longer exist in NATPool
<poolname>
Explanation
The translation IP has been removed by a configuration change. The
connection is no longer valid and will be closed.
Gateway Action
close
Recommended Action
None.
Revision
1
Parameters
address
poolname
2.28.3. reconf_state_violation (ID: 05600003)
Default Severity
NOTICE
Log Message
State violation during re-mapping to STATFUL NATPool
<poolname>.
Explanation
The NATPool's configuration has changed to STATEFUL. This
connection's translation IP violates the stateful NATPool. Connection
will remain open but will no longer be attached to this NATPool.
Gateway Action
decouple
Recommended Action
None.
2.28. NATPOOL Chapter 2. Log Message Reference
333