D-Link NetDefend DFL-210

Default Severity
ERROR
Log Message
IPsec interface disabled
Explanation
IPsec interface disabled.
Gateway Action
None
Recommended Action
None.
Revision
1
2.22.66. maximum_allowed_tunnels_limit_reached (ID:
01800900)
Default Severity
ALERT
Log Message
Negotiation aborted due to license restrictions. Reached maximum of
<allowed_tunnels> active IPsec tunnels
Explanation
More tunnels and/or unique peers than the license allow are trying to
establish.
Gateway Action
negotiation_aborted
Recommended Action
None.
Revision
1
Parameters
allowed_tunnels
2.22.67. SAs_not_killed_for_remote_peer (ID: 01800901)
Default Severity
CRITICAL
Log Message
Failed to kill associated SA:s for <remotepeer> peer(s)
Explanation
This happens if there is no tunnel established with the given peer.
Gateway Action
None
Recommended Action
None.
Revision
1
Parameters
remotepeer
2.22.68. sa_write_congestion (ID: 01801337)
Default Severity
INFORMATIONAL
Log Message
Failed to write SA to Nitrox II due to congestion. <dir> SPI <spi>
Explanation
There was not enough free buffers to write the SA to Nitrox II. Every
new packet on the SA will trigger a new try.
2.22.66. maximum_allowed_tunnels_limit_reached
(ID: 01800900)
Chapter 2. Log Message Reference
267