D-Link NetDefend DFL-210

Recommended Action
This is usualy a consequence of low memory or a bad configuration.
Look for previous log messages to find the cause for the interface
being disabled.
Revision
1
Parameters
ipsec_connection
2.22.62. no_remote_gateway (ID: 01800503)
Default Severity
ERROR
Log Message
Remote gateway is null. No route is possible
Explanation
No remote gateway for packet, i.e no route defined.
Gateway Action
packet_will_be_dropped
Recommended Action
None.
Revision
1
2.22.63. no_route (ID: 01800504)
Default Severity
ERROR
Log Message
Failed to lookup route. No route for packet.
Explanation
No remote gateway for packet, i.e no route defined.
Gateway Action
packet_will_be_dropped
Recommended Action
None.
Revision
1
2.22.64. ping_keepalive_failed_in_tunnel (ID: 01800505)
Default Severity
ERROR
Log Message
IPsec ping monitor detects loss if ping replies of packets INSIDE the
tunnel
Explanation
IPsec ping monitor detects loss if ping replies of packets INSIDE the
tunnel.
Gateway Action
tunnel_will_disabled_after_8_number_of_lost_packets
Recommended Action
None.
Revision
1
2.22.65. ipsec_interface_disabled (ID: 01800506)
2.22.62. no_remote_gateway (ID:
01800503)
Chapter 2. Log Message Reference
266