D-Link X-STACK DES-3200 SERIES - Page 101

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
97
Example
To configure a “two rate, three color” flow meter:
DES-3200-28P:admin#config flow_meter profile_id 1 access_id 1 tr_tcm cir 1000
cbs 2000 pir 2000 pbs 2000 color_blind conform permit counter enable exceed
permit replace_dscp 60 counter enable violate drop
Command: config flow_meter profile_id 1 access_id 1 tr_tcm cir 1000 cbs 2000
pir 2000 pbs 2000 color_blind conform permit counter enable exceed permit
replace_dscp 60 counter enable violate drop
Success.
DES-3200-28P:admin#
6-6 show flow_meter
Description
This command is used to display the flow-based metering (ACL Flow Metering) configuration.
Format
show flow_meter {[profile_id <value 1-4> | profile_name <name 32>] {access_id <value 1-
256>}}
Parameters
profile_id - (Optional) Specify the profile ID.
<value 1-4> - Enter the profile ID used here. This value must be between 1 and 4.
profile_name - (Optional) Specify the name of the profile.
<name 32> - Enter the profile name used here. The maximum length is 32 characters.
access_id - (Optional) Specify the access ID.
<value 1-256> - Enter the access ID used here. This value must be between 1 and 256.
Restrictions
None.
Example
To display the flow metering configuration: