D-Link X-STACK DES-3200 SERIES - Page 121

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
117
10-6 enable telnet
Description
This command is used to enable TELNET and configure port number.
Format
enable telnet {<tcp_port_number 1-65535>}
Parameters
<tcp_port_number 1-65535> - (Optional) The TCP port number. TCP ports are numbered
between 1 and 65535. The “well-known” TCP port for the TELNET protocol is 23.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable TELNET and configure port number:
DES-3200-28P:admin#enable telnet 23
Command: enable telnet 23
Success.
DES-3200-28P:admin#
10-7 disable telnet
Description
This command is used to disable TELNET.
Format
disable telnet
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable TELNET: