D-Link X-STACK DES-3200 SERIES - Page 147

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
143
setting regarding STP is not displayed. The lower level setting will only be displayed when the
higher level setting is enabled.
Note: This parameter is only for the current configuration.
modified - Show only the commands which are not default setting.
Note:This parameter is only for the current configuration.
current_config - Specify the current configuration.
boot_up - Specify the list of the bootup configuration.
file - Specify to display the configuration file.
<pathname 64> - The pathname specifies an absolute pathname on the device file system. If
pathname is not specified, the boot up configuration is implied. This name can be up to 64
characters long.
include - (Optional) Include lines that contain the specified filter string.
exclude - (Optional) Exclude lines that contain the specified filter string.
begin - (Optional) The first line that contains the specified filter string will be the first line of the
output.
<filter_string 80> - A filter string is enclosed by symbol ". Thus, the filter string itself cannot
contain the “ character. The filter string is case sensitive. This value can be up to 80
characters long.
<filter_string 80> - (Optional) A filter string is enclosed by symbol ". Thus, the filter string
itself cannot contain the “ character. The filter string is case sensitive. This value can be up
to 80 characters long.
<filter_string 80> - (Optional) A filter string is enclosed by symbol ". Thus, the filter string
itself cannot contain the “ character. The filter string is case sensitive. This value can be
up to 80 characters long.
include - (Optional) Include lines that contain the specified filter string.
exclude - (Optional) Exclude lines that contain the specified filter string.
begin - (Optional) The first line that contains the specified filter string will be the first line of the
output.
<filter_string 80> - A filter string is enclosed by symbol ". Thus, the filter string itself cannot
contain the “ character. The filter string is case sensitive. This value can be up to 80
characters long.
<filter_string 80> - (Optional) A filter string is enclosed by symbol ". Thus, the filter string
itself cannot contain the “ character. The filter string is case sensitive. This value can be up
to 80 characters long.
<filter_string 80> - (Optional) A filter string is enclosed by symbol ". Thus, the filter string
itself cannot contain the “ character. The filter string is case sensitive. This value can be
up to 80 characters long.
include - (Optional) Include lines that contain the specified filter string.
exclude - (Optional) Exclude lines that contain the specified filter string.
begin - (Optional) The first line that contains the specified filter string will be the first line of the
output.
<filter_string 80> - A filter string is enclosed by symbol ". Thus, the filter string itself cannot
contain the “ character. The filter string is case sensitive. This value can be up to 80
characters long.
<filter_string 80> - (Optional) A filter string is enclosed by symbol ". Thus, the filter string
itself cannot contain the “ character. The filter string is case sensitive. This value can be up
to 80 characters long.
<filter_string 80> - (Optional) A filter string is enclosed by symbol ". Thus, the filter string
itself cannot contain the “ character. The filter string is case sensitive. This value can be
up to 80 characters long.
Restrictions
Only Administrator-level users can issue this command.
Example
The following example illustrates how the special filters, ‘modified’, affect the configuration display: