D-Link X-STACK DES-3200 SERIES - Page 148

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
144
DES-3200-28P:admin#show config modified
Command: show config modified
#-------------------------------------------------------------------------------
# DES-3200-28P Fast Ethernet Switch
# Configuration
#
# Firmware: Build 4.03.004
# Copyright(C) 2012 D-Link Corporation. All rights reserved.
#-------------------------------------------------------------------------------
# DEVICE
# BASIC
# ACCOUNT LIST
create account admin admin
admin
admin
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
15-2 config configuration
Description
This command is used to select a configuration file as the next boot up configuration or to apply a
specific configuration to the system. This command is required when multiple configuration files
are supported.
Note: DES-3200 Series with C1 hardware version support file system.
Format
config configuration <pathname 64> [boot_up | active]
Parameters
<pathname 64> - Specify a configuration file on the device file system.
boot_up - Specify it as a boot up file.
active - Specify to apply the configuration.
Restrictions
Only Administrator-level users can issue this command.